3-Point Hitch Hydraulic Selector Valve for RTV X-Series

The hydraulic kit will greatly improve the versatility of your 3-point hitch and your Kubota. It comes equipped with hydraulic quick disconnect valves. The wiring harness is included and the kit will come to you pre-wired. It has 4 hydraulic ports for front and rear hydraulics and uses only the Kubota factory control valve. 

This valve allows for operation of a hitch on the front or rear of the Kubota*, as well as either the dump bed or, snowplow rotation (with the Front Line and Manifold Option) with just a flip of a switch. The directional control switch is the only part of the hydraulic kit that requires any modification to the machine itself drilling just a small hole at the location of your choice near the headlight switch. No other drilling or welding is necessary for installation just the tightening of a couple of clamps.

The picture shows the installation location for this accessory. Complete installation time for both the Hydraulic Selector Valve and the Front Line & Manifold is roughly 45 minutes.

*Front hydraulic lines and manifold are not included in the hydraulic selector kit. This product is available for a small extra charge.